Skip to main content

Free Shipping on Parcel Orders of $49+

See Terms

Now Available: Buy now, pay over time with Affirm – as low as 0%

Apply Now
/
Cart

Waterless Urinals

Cleaning Instructions

Five-Minute Read

Print
Favorites

Daily Cleaning

  • Spray the KOHLER cleaner over the outer surfaces of the urinal.
  • Allow some cleaner to run down the drain.
  • Allow the cleaner to stand for approximately 1 minute.
  • Wipe the outer surfaces with a clean, nonabrasive cloth.
  • If necessary, repeat this procedure for heavier soils still present on the urinal.

Required
Flush Out

  • To minimize odor and avoid sediment buildup in the trapway, it is important to flush out your waterless urinal every two weeks using the following procedure:
  • Repeat the Daily Cleaning procedure.
  • Remove the used urinal ball and discard.
  • Using a small screwdriver or bent wire, carefully lift the strainer vertically from the drain. Clean the strainer and set it aside.
  • Quickly pour 1 gallon of water directly into the drain. Do not let the urinal overflow. This will purge the residual urine and sealing liquid.
  • Unscrew the spray nozzle from the cleaner bottle. Pour 1 ounce or 2 tablespoons of cleaner directly into the drain.
  • Allow the cleaner to stand for 5 to 10 minutes.
  • Pour 2 gallons of water directly into the drain as quickly as possible. Do not let the urinal overflow. Pour 3 ounce or approximately ⅓ cup of sealing liquid directly into the drain. Reinstall the strainer. Set a fresh urinal ball in the urinal.

IMPORTANT!

  • Do not set the urinal ball directly into the drain or force it through the strainer, as this may cause blockage.
  • Always keep the strainer in place over the urinal drain to prevent debris from entering the drain.
  • Do not use cleaners containing antibacterial agents or any urinal puck or mat as these may reduce the effectiveness of the urinal ball.
  • Failure to perform flush-out cleaning may eventually result in a clogged urinal. If the urinal becomes clogged, use a plunger, urinal auger, or non-KOHLER brand strong acid cleaner. If you use a non-KOHLER brand strong acid cleaner, thoroughly rinse the urinal with water after application to minimize acid corrosion on the seal gasket and downstream piping.